软管泵滑模机值得买

公司软管泵产品驱动形式，电机+无级变速器。
主要特点：调速精度高，变速范围大（速比可在1：1.4-1：7之间任意变化），可连续工作运转，运转平稳，性能稳定，噪音低，扭矩大，流量无级可调。但它的变速是需手动来调节，自动化程度不高，调速须在运转中进行，不可停车时转动调速手轮。它不宜用于可能超负荷或堵塞使用场合。                                 

首先我们先介绍一下软管泵，软管泵又称蠕动泵。为了消除泵体污染流体或流体污染泵体的危险性，整个泵的装置中只有软管与介质接触。在一般场合下，软管泵使用的都是天然橡胶的软管。内层和外层都是完整光滑的天然橡胶，其目的是很强防磨损。适用于腐蚀性不高但磨损性很大的如泥浆以及无机物等等介质。而且一般适用于脂肪、油类或油脂的介质，以及有机化学物质。内层是橡胶，而外层是天然橡胶或者是复合橡胶。

First of all, lets introduce the hose pump, which is also called peristaltic pump. In order to eliminate the danger of the pump body contaminating the fluid or the fluid contaminating the pump body, only the hose in contact with the medium in the entire pump device. In general, hose pumps use natural rubber hoses. The inner and outer layers are completely smooth natural rubber, the purpose of which is to prevent abrasion. It is suitable for mediums that are not corrosive but very abrasive, such as mud and inorganic substances. And generally suitable for fats, oils or oils, and organic chemicals. The inner layer is rubber, while the outer layer is natural rubber or composite rubber.

 

工业软管泵不锈钢齿轮泵，可输送非润滑油饮料低腐蚀性液体，配铜齿轮可输送汽油苯等低内点液体。由于齿轮泵自吸能力差，一般是由于齿轮泵泵腔间隙较大所致。同时也是如果齿轮泵输出端没有“止回阀”，则必须是下一级齿轮泵的止回阀或控制阀。移动固定后，周围工作人员可恢复手术。

Industrial hose pump stainless steel gear pump, can transport non-lubricant beverages with low corrosive liquids, with copper gears can transport gasoline, benzene and other low internal point liquids. Due to the poor self-priming ability of the gear pump, it is generally caused by the large gap between the pump cavity of the gear pump. At the same time, if there is no "check valve" at the output of the gear pump, it must be a check valve or control valve of the next gear pump. After moving and fixing, the surrounding staff can resume surgery.